Method on the microstructural and mechanical features (Contributo in atti di convegno)

Type

• Prodotto della ricerca (Classe)
• Contributo in atti di convegno (Classe)

Label

• Method on the microstructural and mechanical features (Contributo in atti di convegno) (literal)

Anno

• 2009-01-01T00:00:00+01:00 (literal)

Alternative label

• Faga M. G.; Calzavarini R.; Mattioda R.; Settineri L. (2009)
  Method on the microstructural and mechanical features
  in 7th International Conference on Industrial Tools and Material Processing Technologies, Ljubljana, Slovenia
  (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#autori

• Faga M. G.; Calzavarini R.; Mattioda R.; Settineri L. (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#note

• In: ICIT&MPT - 7th International Conference on Industrial Tools and Material Processing Technologies (Ljubljana, Slovenia, 4-7 October 2009). Proceedings, pp. 203 - 206. Gasper Gantar (ed.). TECOS Slovenian Tool and Die Development Centre, Celje, 2009. (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#descrizioneSinteticaDelProdotto

• ABSTRACT: WC-Co based materials are widely used for cutting tools because of the good combination of hardness and toughness, that can be properly modulated by varying the percentage of additional carbides and binders. However, powders for the materials preparation are rare and, for this reason, research is addressed to recycle the worn materials. A new recycling process has been proposed by Wolframcarb; such method allows the almost complete recycling of WC-based materials with a low environmental impact. This paper deals with the analysis of microstructural and wear properties of WC-Cobased materials prepared in form of cutting tools via recycling and traditional methods. Evaluation of efficiency in turning with application to 100Cr6, AISI 304 and Inconel 718 was considered, using uncoated and CVD coated tools and varying the grade of hard metals (K20, P40 and M30 were employed, depending on the workpiece to be machined). Analysis of microstructure and wear resistance as a function of (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#affiliazioni

• CNR-ISTEC, Faenza, Wolframcarb Factory, Via Brezzi 26, 10081 Castellamonte (TO), Italy, Department of Production Systems and Business Economics, Corso Duca degli Abruzzi 24, Turin, Italy (literal)

Titolo

• Method on the microstructural and mechanical features (literal)

Prodotto di

• Institute of science and technology for ceramics (ISTEC) (Istituto)

Autore CNR

• ROBERTO CALZAVARINI (Persona)
• LUCA SETTINERI (Unità di personale esterno)
• MARIA GIULIA FAGA (Unità di personale interno)

Insieme di parole chiave

• Keywords of "Method on the microstructural and mechanical features" (Insieme di parole chiave)

Incoming links:

Prodotto

• Institute of science and technology for ceramics (ISTEC) (Istituto)

Autore CNR di

• MARIA GIULIA FAGA (Unità di personale interno)
• ROBERTO CALZAVARINI (Persona)
• LUCA SETTINERI (Unità di personale esterno)

Insieme di parole chiave di

• Keywords of "Method on the microstructural and mechanical features" (Insieme di parole chiave)