A new multipurpose UV-Vis spectrometer for air quality monitoring and climatic studies (Articolo in rivista)

Type
Label
  • A new multipurpose UV-Vis spectrometer for air quality monitoring and climatic studies (Articolo in rivista) (literal)
Anno
  • 2010-01-01T00:00:00+01:00 (literal)
Alternative label
  • Bortoli D., A.M. Silva, G. Giovanelli (2010)
    A new multipurpose UV-Vis spectrometer for air quality monitoring and climatic studies
    in International journal of remote sensing (Print)
    (literal)
Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#autori
  • Bortoli D., A.M. Silva, G. Giovanelli (literal)
Pagina inizio
  • 705 (literal)
Pagina fine
  • 725 (literal)
Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#numeroVolume
  • 31 (literal)
Rivista
Note
  • ISI Web of Science (WOS) (literal)
Titolo
  • A new multipurpose UV-Vis spectrometer for air quality monitoring and climatic studies (literal)
Abstract
  • The multipurpose ultraviolet-visible (UV-Vis) remote sensing equipment SPATRAM (SPectrometer for Atmospheric TRAcers Monitoring) is a scanning spectrometer for measurement of electromagnetic radiation in the 250–950 nm spectral range. In this paper SPATRAM will be presented and new solutions will be discussed. The monochromator is based on the one installed in GASCOD (Gas Analyzer Spectrometer CorrelatingOptical Differences) developed during the 1990s. The most important improvements of SPATRAM relative to GASCOD are: (i) the wider spectral range scanned, allowing for the detection of more atmospheric compounds than with GASCOD; (ii) an increased number of inputs, resulting in the possibility of quasi-simultaneous measurements from different optical devices; (iii) the focusing optic system, which permits a simple optical alignment procedure and low cost; (iv) electronic self-thermoregulation, allowing for reliable spectral measurements unaffected by mechanical deformation caused by variation of temperature; (v) adoption of a CCD sensor, resulting in an increase of equipment sensitivity and therefore an enhancement in time resolution of the measurements; (vi) the use of an advanced CPUand a standardOS, guaranteeing full stability of the equipment; and (vii) the development of a new software tool for complete control of the whole instrument and for pre-processing of the measured data. (literal)
Prodotto di
Autore CNR

Incoming links:


Prodotto
Autore CNR di
Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#rivistaDi
data.CNR.it