http://www.cnr.it/ontology/cnr/individuo/prodotto/ID285626
Engine performance and emissions of a small diesel engine fueled with various diesel/RME blends (Articolo in rivista)
- Type
- Label
- Engine performance and emissions of a small diesel engine fueled with various diesel/RME blends (Articolo in rivista) (literal)
- Anno
- 2014-01-01T00:00:00+01:00 (literal)
- Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#doi
- 10.4271/2014-32-0135 (literal)
- Alternative label
S.di Iorio, A.Magno, E.Mancaruso, B.M.Vaglieco,L.Arnone,L.Dal Bello (2014)
Engine performance and emissions of a small diesel engine fueled with various diesel/RME blends
in SAE technical paper series
(literal)
- Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#autori
- S.di Iorio, A.Magno, E.Mancaruso, B.M.Vaglieco,L.Arnone,L.Dal Bello (literal)
- Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#altreInformazioni
- SAE TECHNICAL PAPER 2014-32-0135 (literal)
- Rivista
- Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#pagineTotali
- Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#affiliazioni
- L.Arnone - Lombardini s.r.l.
L.Dal Bello -Lombardini s.r.l. (literal)
- Titolo
- Engine performance and emissions of a small diesel engine fueled with various diesel/RME blends (literal)
- Abstract
- The present paper describes the results of an experimental
activity performed on a small diesel engine for quadricycles, a
category of vehicles that is spreading in Europe and is recently
spreading over Indian countries. The engine is a prototype
three-cylinder with 1000 cc of displacement and it is equipped
with a direct common-rail injection system that reaches a
maximum pressure of 1400 bar. The engine was designed to
comply with Euro 4 emission standard that is a future
regulation for quadricycles. It is worth underlining that the
engine can meet emission limits just with EGR system and a
DOC, without DPF. Various diesel/RME blends were tested;
pure diesel and biodiesel fuels were also used. The
investigation was carried out at the engine speeds of 1400,
2000 and 3400 rpm and full load. Combustion characteristics
of both blended and pure RME were analyzed by means of
in-cylinder pressure and heat released histories. A smoke
meter was used to determine the particulate matter
concentration. The sizing and the counting of the particles were
performed in the range 5.6-560 nm. Gaseous emissions were
measured at the exhaust. Lower exhaust emissions were
measured when the engine runs with pure RME with respect to
diesel fuel in terms of CO, HC, NOx, PM and particle number.
From the analysis of the data it can be argued that a proper
engine calibration could further optimize the combustion
process and emission formation when the engine is fueled with
RME blends. (literal)
- Prodotto di
- Autore CNR
Incoming links:
- Prodotto
- Autore CNR di
- Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#rivistaDi