http://www.cnr.it/ontology/cnr/individuo/prodotto/ID275562

Dry and moist convection in the boundary layer over the Black Forest - a combined analysis of in situ and remote sensing data (Articolo in rivista)

Type

Prodotto della ricerca (Classe)
Articolo in rivista (Classe)

Label

Dry and moist convection in the boundary layer over the Black Forest - a combined analysis of in situ and remote sensing data (Articolo in rivista) (literal)

Anno

2013-01-01T00:00:00+01:00 (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#doi

10.1127/0941-2948/2013/0417 (literal)

Alternative label

Kalthoff, N [ 1 ] ; Traumner, K [ 1 ] ; Adler, B [ 1 ] ; Spath, S [ 1 ] ; Behrendt, A [ 2 ] ; Wieser, A [ 1 ] ; Handwerker, J [ 1 ] ; Madonna, F [ 3 ] ; Wulfmeyer, V [ 2 ] (2013)
Dry and moist convection in the boundary layer over the Black Forest - a combined analysis of in situ and remote sensing data
in Meteorologische Zeitschrift (Berl.); E SCHWEIZERBARTSCHE VERLAGS, Stuttgart (Germania)
(literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#autori

Kalthoff, N [ 1 ] ; Traumner, K [ 1 ] ; Adler, B [ 1 ] ; Spath, S [ 1 ] ; Behrendt, A [ 2 ] ; Wieser, A [ 1 ] ; Handwerker, J [ 1 ] ; Madonna, F [ 3 ] ; Wulfmeyer, V [ 2 ] (literal)

Pagina inizio

445 (literal)

Pagina fine

461 (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#numeroVolume

22 (literal)

Rivista

Meteorologische Zeitschrift (Rivista)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#pagineTotali

17 (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#numeroFascicolo

4 (literal)

Note

ISI Web of Science (WOS) (literal)
Scopu (literal)

Http://www.cnr.it/ontology/cnr/pubblicazioni.owl#affiliazioni

[ 1 ] KIT, Inst Meteorol & Klimaforsch IMK TRO, Karlsruhe, Germany [ 2 ] Univ Hohenheim, Inst Phys & Meteorol, Stuttgart, Germany [ 3 ] CNR, IMAA, Istituto di metodologie per l'analisi ambientale, 85050 tito Scalo, Potenza, Italy (literal)

Titolo

Dry and moist convection in the boundary layer over the Black Forest - a combined analysis of in situ and remote sensing data (literal)

Abstract

During the COPS experiment performed in south-western Germany and eastern France in 2007, several in-situ and remote sensing systems were operated at Hornisgrinde - the highest summit of the northern Black Forest mountains. For this case study, data from a surface flux station, radiosondes, cloud camera, cloud radar, wind lidar, water vapour differential absorption lidar, and microwave profiler were used to investigate turbulence characteristics in cloud-free and cloud-topped convective boundary layers (CBLs). Short time intervals were analysed, during which dry and moist convective cells occurred, in order to obtain insight of the processes that determine the turbulent characteristic in the CBL. The frequently-used aerosol concentration was used to calculate the CBL height, z(i). It was found that active CBL clouds penetrated deeper into the free troposphere than dry convective cells. In the cloud-free CBL the normalised variance of the vertical velocity, sigma(2)(w), decreased to zero approximately at z(i), while sigma(2)(w) was nearly constant between 0.5 and 1 z/z(i) in the cloud-topped CBL. The higher normalised sigma(2)(w) values in the cloud layer could be attributed to the additional elevated heat source due to condensation. In the cloud-free CBL the latent heat flux showed a strong decrease between 0.7 and 1.1 z/z(i), i.e., it considerably moistened the upper part of the CBL and entrainment zone. In the cloud-topped CBL the latent heat flux decreased significantly above the CBL top only and became zero at about 1.4 z/z(i). CBL height calculations, which took measures of the turbulence into account, resulted in normalised sigma(2)(w) and E profiles, which became zero at the CBL top and appeared more appropriate for CBL height scaling over complex terrain. The case studies demonstrated that only the combined use of different monitoring systems allowed for the recording of the entire structure of the convective cells and that synergetic measurements in cloud-topped CBLs were indispensable to capture the latters' turbulent characteristics. Also, significant differences between turbulent characteristics in cloud-free and cloud-topped CBLs became evident. (literal)

Editore